Table of Contents
Advertisement
Color profile: Generic CMYK printer profile
Composite
Default screen
Installation and set-up
6
Fit the rechargeable batteries in each handset
A
. Fit the three
batteries as
shown, making
sure you match
the
+
and
–
ends
to the markings
in the battery
compartment
!
DON'T use non-rechargeable batteries in the handset.
7
Charge the batteries for 15 hours
Before you use the handset for
the first time, it's important to
The battery
charge the batteries fully.
level symbol
blinks
The handset 'beeps' when it's
correctly in position on the
charging cradle.
Leave the handset on the charging cradle
for 15 hours.
The battery charge level symbol should increase
by one bar every half hour when you're charging
an empty battery. If you think that the symbol
isn't showing the correct battery charge level,
remove and refit the batteries.
8
Connect the base unit to the telephone line
Switch off power at the mains socket
Insert the telephone line plug into
the socket as shown
Switch mains power back on
Make sure the mains socket is
switched on if you want to use
the phone — it will not work
without electrical power
6
E:\Binatone2004\Lifestyle\Lifestyle_100\Lifestyle-100_UK_01.vp
14 April 2004 15:14:05
B. Fit the
battery
compartment
cover, sliding it
into place and
pressing firmly
to make sure it
is secure
1
1
The Charge
light comes on.
Use the plug to
raise the shutter
before pushing
it into the socket
NOTE: the charger pod does not have
a connection to the telephone line.
Before you start
Electrical
DO NOT let the base unit or charger pod get wet.
safety
Electrical equipment can cause serious injury if used
while you are wet or standing in water.
If the base unit or charger pod ever falls into water, DO
NOT retrieve it until you have unplugged the power
lead from the mains and the telephone line plug from
the telephone socket (base unit only); then pull it out by
the unplugged cables.
NEVER use your Lifestyle 100 outdoors during a
thunderstorm — unplug the base unit from the
telephone line and the mains socket when there are
storms in your area. Damage caused by lightning is not
covered by the guarantee.
Interference
If the sound quality gets worse as you move around
while on a call, this is probably caused by interference
between the handset and the base unit, perhaps
because you are too near to another phone or other
electrical equipment.
Move to a different position to clear the interference.
If you do not move, your call may be cut off.
Radio interference in the environment may occasionally
!
cause a short break in the link between the handset
and the base unit while you are on a call. The
handset's display will flash briefly, while the unit
automatically restores the link.
'Out of range'
If you hear a warning tone during a call, and/or the
warning
sound in the earpiece becomes faint or distorted, you
may be going out of range of the base unit. Move
nearer to the base unit within 20 seconds, until the
tone stops. Otherwise, your call may be cut off.
Binatone Help Line: 0845 345 9677
(Local Call rate)
7
Advertisement
Table of Contents
