The Rear Panel - Crate FlexWave 120H Owner's Manual

FlexWave120H Guitar Amplifier w/DSP and Channel Tracking
OVERDRIVE
HIGH GAIN
0 0 10 10 0 0 10 10
LEVEL SHAPE
HIGH GAIN
18 19 20 21

The Rear Panel

FOOTSWITCH
INSERT CHANNEL DSP EXT SPKR
CLEAN / OD BANK A
HIGH GAIN BANK B
25 26 27
25. INSERT: Use this jack to connect an
external signal processor to the amplifier. Use
Crate's STP201, STP202, or STP203 stereo-
to-mono Y-cord or an adapter such as Crate's
YPP117 and two 1/4" mono signal cables to
connect to the effect, as shown below.
26. CHANNEL FOOTSWITCH: Use this jack
to connect one of the footswitch cables to the
three-button footswitch (supplied). This allows
you to remotely switch between the Clean,
High Gain, and Overdrive
channels. Additional infor-
mation about the opera-
tion of the footswitch is
on page 8.
27. DSP FOOTSWITCH:
Use this jack to connect
one of the footswitch
cables to the three-but-
ton footswitch (supplied).
This allows you to select
between two DSP pre-
sets for each of the three
channels. Additional infor-
mation about the opera-
tion of the footswitch is
on page 8.
6
INPUT
0 0 10 10
GAIN
22 23 24
4 OHM
MIN LOAD
28
Stereo-to-mono Y-cord:
TIP RETURN
to Insert
RING SEND
jack
SLEEVE GROUND
(STP201, 3'
STP202, 6'
STP203, 9')
to to
effect effect
"OUT" "IN"
jack jack
External Effect
21. SHAPE: Use this control to "dial in"
the tone for the High Gain channel. Rotating
this control counter-clockwise enhances the
mid frequencies, while rotating it clockwise
enhances the low and high frequencies.
22. GAIN: Use this control to adjust the
amount of distortion for the High Gain channel.
23. HIGH GAIN LED: This LED illuminates
when the High Gain channel is selected.
24. INPUT: Use this jack to connect your
guitar to the amplifier by means of a shield-
ed instrument cable.
29
28. EXTENSION SPEAKER: Use this jack
to connect the amplifier to an external
speaker cabinet.
Note: The external speaker cabinet should
have a nominal impedance of 4 ohms or higher.
29. FUSE: The fuse protects the amplifier
from damage caused by a faulty AC power
source or other problems. If the fuse opens,
replace it with the same size and type. If
fuses continue to fail, check the AC source.
If the source is okay,
Y-adapter and 2 cables:
refer to page 12 or con-
TIP
to Insert
RING
jack tact your Crate dealer
SLEEVE
for service information.
30. POWER CORD:
(YPP117)
This grounded power
cord is to be plugged
into a grounded power
outlet, wired to current
electrical codes and
compatible with the
voltage, power, and
(1/4"-TO-1/4"
frequency requirements
MONO SHIELDED
CABLES)
stated on the rear panel.
to to
Do not attempt to defeat
effect effect
"OUT" "IN"
the safety ground con-
jack jack
nection!
External Effect
100 VAC: 250V T4A
120 VAC: 250V T3A
230/240 VAC: 250V T1.6A
30