Download Print this page

American Water Heater 319339-000 Specification Sheet

Heater 50-gallon residential high efficency water heater specification sheet

Advertisement

Quick Links

90% THERMAL EFFICIENCY CONTINUOUS HOT WATER VERSATILE
POWER VENT DESIGN
• Today's homes demand more hot water than ever before, and the 90% efficient
the need. The 50-gallon water heater delivers hot water output that rivals a 75-gallon
atmospheric gas water heater. In fact, the fully condensing design is so advanced, it can
deliver "endless hot water for showers"...a continuous flow of over 3 gallons per minute.
* Yet it is easy to install, with height, diameter and installation requirements similar to
standard power-vent units.
HELICAL INTERNAL HEAT EXCHANGER
• Positioned in the center of the tank, surrounded by water to virtually eliminate radiant heat loss from
the chamber
over time.
POWER VENTS USING PVC PIPE
• Combined vertical and horizontal vent runs terminating through an outside wall, using Schedule 40
PVC pipe
• Can be vented vertically thru-the-roof or horizontally thru-the-wall
– 2" pipe, vents up to 45 equivalent feet
– 3" pipe, vents up to 128 equivalent feet
– 4" pipe, vents up to 128 equivalent feet
MODULAR BLOWER
• Equipped with 120 volt, 60 Hz electrical system (rating 5 amps or less), 6-foot cord with standard
3-prong connector
• 2" PVC pipe, elbows and condensate drain supplied to connect heat exchanger outlet to blower
• PVC Vent Attenuation Assembly (VAA) supplied
SIDE-MOUNTED HOT AND COLD RECIRCULATING TAPS
• Allows water heater to be installed as part of combination space heating/water heating applications or
INTELLI-VENT™** GAS CONTROL
• Equipped with nearly indestructible silicon nitride hot surface ignitor — no standing pilot
• Advanced electronics for more precise control of water temperature and easy-to-understand
system diagnostics
COMMERCIAL GRADE GLASS LINING
• Provides superior protection against corrosion
• Protects all interior tank surfaces including inside and outside of helical heat exchanger
TWO HEAVY-DUTY ANODE RODS
• Provides added protection against corrosion
GREEN CHOICE® GAS BURNER
• Patented "Eco-Friendly" design reduces NOx emissions by up to 33% and meets less than
40ng/j requirements for low NOx
CSA CERTIFIED AND ASME RATED T&P RELIEF VALVE
MAXIMUM HYDROSTATIC WORKING PRESSURE: 150 PSI
**Intelli-Vent is a registered trademark of Emerson Electric Company
*For complete warranty information consult the written warranty of American Water Heaters found at www.americanwaterheater.com, or call (800) 456-9805.
Copyright© by American® Water Heaters 2008. All rights reserved.
Copyright© by American® Water Heaters 2011. All rights reserved.
No part of this work may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, or by any information storage retrieval system, without permission in writing from American Water Heaters.
6-Year Limited Tank/ 6-Year Limited Parts Warranty*

Residential Gas

VG6250T76NV
NRGSS01110
May 2011R

Advertisement

loading

Summary of Contents for American Water Heater 319339-000

  • Page 1: Residential Gas

    90% THERMAL EFFICIENCY CONTINUOUS HOT WATER VERSATILE POWER VENT DESIGN • Today’s homes demand more hot water than ever before, and the 90% efficient the need. The 50-gallon water heater delivers hot water output that rivals a 75-gallon atmospheric gas water heater. In fact, the fully condensing design is so advanced, it can deliver “endless hot water for showers”…a continuous flow of over 3 gallons per minute.
  • Page 2: Warranty And Service

    90% THERMAL EFFICIENCY POWER VENT CODES AND STANDARDS • Design-certified by UL (Underwriters Laboratories) according to ANSI Z21.10.3 - CSA 4.3 Standards • Meets the thermal efficiency and standby loss requirements of the U.S. Department of Energy and current edition ASHRAE/IESNA 90.1 FIRST HOUR GALLONS DELIVERY...

This manual is also suitable for:

Nrgss01110Vg6250t76nv