Preparation; Attaching The Stand Unit - Sharp LC-90LE757E Operation Manual

Preparation

Attaching the stand unit

• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work, spread cushioning over the surface on which you will be laying
the TV. This will prevent it from being damaged.
• Be sure that two or more persons attach the stand.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in
the TV falling over.
• After attaching the stand to the TV, do not hold the stand when you put up, set up,
move or lay down the TV.
• Do not remove the stand from the TV unless using a wall mount bracket to mount
it.
1
Confirm that there are 12 screws (eight M6 screws, four M5 screws) supplied
with the stand unit.
2
1
Set the supporting post for the stand unit onto the polystyrene foam.
2
Attach the stand base to the supporting post.
3
Insert and tighten the M6 screws (length: 16mm) into the eight holes on
the bottom of the stand base.
• Hold the stand unit securely with one hand, and then tighten the screws.
w For 80/90 inch models
Stand base
2
1
Supporting post
3
Long
screws
1
FRONT
w For 70 inch models
Stand base
Supporting post
3
Insert the stand into the openings on the bottom of the TV (hold the stand so
it will not drop from the edge of the base area).
• Make sure that the stand is firmly inserted into the TV. Improper installation may
result in tilting of the TV set.
• Instead of using a soft cushion, the cardboard box that the TV is packed in can
be assembled and used as a work table (refer to the instructions on the box to
assemble the work table).
5
Long screws
TV front
Soft cushion