Controls And Input Connections - Toshiba Regza Owner's Manual

Controls and input connections

A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
GREEN LED – Active standby
RED LED – Power on
Switching on
If the RED LED is unlit check that the mains plug is
connected to the power supply. If the picture does not
appear press i on the remote control, it may take a few
moments.
To put the television into Standby press
control, the GREEN active standby LED will appear
(see 'Software Upgrade' section) next to the RED for a few
moments then disappear. To view the television press
again. The picture may take a few seconds to appear.
Using the remote control
Press the MENU button on the remote control to see
the menus.
In digital mode the menu bar at the top of the screens
will show three different topics shown in symbols. As each
symbol is selected by pressing the S or R button on the
remote control, its respective options will appear below.
In analogue mode the menu appears as a list of five
topics. As each symbol is selected by pressing the S or
R button on the remote control, its respective options will
appear below.
on the remote
i
i
8
Standby
To use the options press the P and Q button on the
remote control to move up and down through them and
OK, S or R to select the required choice. Follow the on
screen instructions. The functions of each menu are
described in detail throughout the manual.
Using the controls and connections
To alter the volume press —
To alter the programme position press
Press MENU and S , R , Q or P to control the sound
and picture options.
Press MENU twice to finish.
When connecting sound equipment to EXT3, connect
the audio output of the equipment to the phono sockets
on the television.
B
To select the Input, press
EXT3 as described on page 31. The television will
automatically sense the type of signal.
Please always refer to the owner's manual of the
equipment to be connected for full details.
Please note: Inserting the headphone plug will mute the
sound from all speakers.
INPUT 3
(EXT3)
+
.
j
e e f f .
F
until the display shows