ViewSonic PJD5453s User Manual page 35

• The default setting is "Auto" when input source is HDMI.
• The default setting is "Side-by-Side" when input source is video or computer. "Auto"
will be unavailable.
• The brightness level of the projected image will decrease.
• The Color Mode cannot be adjusted.
• 3D Invert
• On: Invert left and right frame contents.
• Off: Default frame contents.
Video/Audio
Frequency
Adjust the timing of the projector relative to the computer.
Note
• This functions is only supported under computer mode.
Tracking
Adjust the phase of the projector relative to the computer.
Note
• This functions is only supported under computer mode.
H Position (Horizontal Position)
Adjust the image left or right within the projection area.
V Position (Vertical Position)
Adjust the image up or down within the projection area.
Zoom
Using the remote control
1. Press Magnify on the remote control to display the Zoom bar.
2. Press / to magnify the picture to a desired size.
3. Press Enter on the remote control to switch to the paning mode and press the
directional arrows to navigate the picture. The zoom bar needed to be shown on
screen if we want to switch the paning mode.
4. To reduce size of the picture, press Magnify and press
restored to the original size.
Using the OSD menu
1. Press MENU/EXIT on the projector or Menu on the remote control and then press
until the Video/Audio menu is highlighted.
2. Press to highlight Zoom.
3. Repeat steps 2-4 in the section of Using the remote control above.
Video Setting
Allow you to enter the Video Setting menu.
• Sharpness: Sharpen or soften the image.
repeatedly until it is
28