Iso Installation; Fuse; Reconnect Battery; Remove The Unit - Pioneer DVH-865AVBT Operation Manual

Section
04 Installation

ISO installation

This unit has threaded holes in the chassis
side panels which may be used with the
original factory mounting brackets of
some vehicles to mount the radio to the
dashboard. Please consult with your local
car stereo shop for assistance on this type
of installation.
1 Remove the existing factory radio
from the dashboard or center console
m o u n t i n g . S a v e a l l h a r d w a r e a n d
brackets as they will be used to mount
the new radio.
2 Carefully unsnap the plastic frame from
the front of the new unit chassis. Remove
and discard the frame.
3 Remove the factory mounting brackets
and hardware from the existing unit
and attach them to the new unit. Do not
exceed M5 x 6mm maximum screw size.
Longer screws may damage components
inside the chassis.
4 Wire the new unit as outlined in the
Mounting Sleeve Installation instructions.
5 Mount the new unit assembly to the
dashboard or center console using the
reverse procedure of step 1.

Fuse

When replacing a fuse, make sure the new
fuse is the correct type and amperage.
Using an incorrect fuse could damage the
radio.

Reconnect battery

When wiring is complete, reconnect the
battery negative terminal.
30
En

Remove the Unit

1. Remove the panel (Reference page 10).
2. Remove the trim ring by firmly grasping
one side and pulling.
3. Insert the removal keys straight back
until they lock, then pull the radio out.
If the removal keys are inserted at an
angle, they will not lock properly and will
not release the unit.