Table of Contents
Advertisement
Z I P P I E G S
2. An axle is not locked until the quick-release button pops out
fully. An unlocked axle may come off during use, resulting in a
fall, tip-over or loss of control and cause severe injury to the
rider or others.
3. Routinely inspect. Replace if worn or bent.
• Quick-Release Axles should be inspected for function and
any signs of wear or bending. Replace as necessary.
Routinely Inspect. Replace if worn or bent.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
L. REAR WHEELS
A change in set-up of the rear wheels will affect the
center of balance of your chair.
1. The farther you move the rear axles FORWARD, the more
likely it is that your chair will tip over backward.
2. Consult your doctor, nurse or therapist to find the best rear
axle set-up for your chair. Do not change the set-up UNLESS
you are sure you are not at risk to tip over.
3. Adjust the rear wheel locks after you make any change to the
rear axles.
a. If you fail to do so, the locks may not work.
b. Make sure lock arms embed in tires at least 1/8 inch
when locked.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
M. REAR WHEEL LOCKS
Rear wheel locks are NOT designed to slow or stop a
moving wheelchair. Use the only to keep the rear wheels
from rolling when your chair is at a complete stop.
1. NEVER use rear wheel locks to try to slow or stop your
chair when it is moving. Doing so may cause you to veer out
of control.
2. To keep the rear wheels from rolling, always set both rear
wheel locks when you transfer to or from your chair.
3. Low pressure in a rear tire may cause the wheel lock on that
side to slip and may allow the wheel to turn when you do
not expect it.
4. Make sure lock arms embed in tires at least 1/8 inch when
locked. If you fail to do so, the locks may not work.
If you fail to heed these warnings damage to your chair, a fall, tip-
over or loss of control may occur and cause severe injury to the
rider or others.
930377 Rev. F
WARNING
WARNING
WARNING
N.MODIFIED SEAT SYSTEMS
Use of a seat system not approved by Sunrise may alter
the center of balance of this chair. This may cause the
chair to tip over.
1. Do not change the seat system of your chair UNLESS you
consult your authorized supplier first.
2. Use of a seat system not approved by Sunrise may affect the
folding mechanism of this chair.
3. Use of a seating system not provided by Sunrise is prohibited
for transit use.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
O. UPHOLSTERY FABRIC
1. Replace worn or torn fabric of seat and seat back as soon as
you can. If you fail to do so, the seat may fail.
2. Sling fabric will weaken with age and use. Look for fraying or
thin spots, or stretching of fabrics at rivet holes.
3. "Dropping down" into your chair will weaken fabric and
result in the need to inspect and replace the seat more often.
4. Be aware that laundering or excess moisture will reduce
flame retardation of the fabric.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
12
WARNING
WARNING
V I I I .
Advertisement
Table of Contents
