Installation Of The Base Using Uas - Baby Trend FLEX-LOC Owner's Manual

INSTALLATION
7.0
8. A lap/shoulder combination seat belt with a
buckle that can slide freely along the seat
belt may require the use of a locking clip.
(Fig. 42-2) Check your vehicle's owner's
manual to see if the vehicle manufacturer
has provided an alternate manner, such
as a locking retractor in which to prevent
movement of the lap portion of the seat belt.
• To install the locking clip, tighten the
buckled seat belt by pulling upward on
the shoulder portion of the seat belt
while pushing down hard on the Infant
Seat or Base.
• While maintaining downward pressure
on the Infant Seat or Base, squeeze the
shoulder belt and lap belt together just
above the buckle to prevent from moving.
Unbuckle the seat belt being careful to
prevent movement of the buckle.
• Secure the shoulder belt to the lap belt
by installing the locking clip 1.27cm (1/2")
from the buckle as shown in Fig. 42-3.
• Re-buckle the seat belt and check that the
seat belt is very tight around the Infant
Seat or Base. Pull on the lap belt to
ensure that the locking clip is locking the
lap belt and it remains very tight.
42
9. If you are using the Base, check
that nothing is on top of the base, or
anything that will interfere with the
proper latching of the Infant Seat
to the Base. Place the Infant Seat
onto the Base and push down until
Fig. 42-1
the Infant Seat latches securely to
the Base and you hear a click. Pull
upward on the Infant Seat to check
that the Infant Seat is securely
latched onto the base. (Fig. 43-1)
If the Infant Seat does not securely latch onto the Base, the Infant
Seat will NOT provide Protection for your child. DO NOT use the
Infant Seat with the Base if it does not securely latch into place.
Fig. 42-2
Please call Baby Trend at 1-800-328-7363 for assistance.

7.3 Installation of the Base using UAS

Universal Anchorage System (UAS) is designed to make
installation of Infant Seats easier by requiring Infant Seats to be
installed without using the vehicle's seat belt system. If vehicle is
equipped with UAS, the vehicle lower anchor points may be visible
Fig. 42-3
at the vehicle seat crease. If not visible, they may be marked with
the symbol. See your vehicle owner's manual for exact locations,
anchor identification, and requirements for use with an Infant Seat.
INSTALLATION
7.0
Fig. 43-1
43