Attaching The Canopy; Adjustment Of The Shoulder Straps - Baby Trend FLEX-LOC Owner's Manual

FEATURES
5.0

5.8 Attaching the Canopy

Slip the canopy stays through the sleeves on
the canopy.
The canopy is attached by inserting the ends of
the canopy plastic stays into the female fittings
found on the inside of the handle hub.

5.9 Adjustment of the Shoulder Straps

WARNING
Failure to properly adjust the harness on your child
increases the risk of death or serious injury in the event
of a sharp turn, sudden stop or crash. Please follow the
instructions very closely to ensure that the harness is
properly adjusted to fit your child at all times. Your child will
grow very rapidly! Please check the fit of the harness every
time you use the Infant Seat.
Adjustable Back Infant Seat
The Adjustable Back Infant Seat includes a sliding back
component that will adjust the height of the harness straps as the
back is adjusted.
28
To adjust the seat back height, turn the moving
back adjuster knob behind the seat clockwise
to increase the seat back height and counter
clockwise to decrease the seat back height. Each
half turn will raise or lower the slots 1.25cm (1/2").
The proper height of the harness straps is
even with or just below your child's shoulders.
Remove the Infant Seat from the Base and
rotate the Carry Handle to the non rocking
position. Place your child in the Infant Seat
such that your child's bottom is all the way to
the rear and bottom of the seat. (See Fig. 35-2)
Rotate the knob behind the seat back to raise
or lower the moving seat back and harness
straps. Knob must remain in vertical position
after adjustment. (Fig. 29-1) The Harness
Straps must be even with or just below the
child's shoulders. (Fig. 29-2) DO NOT use the
Infant Seat with the Harness adjusted above
the child's shoulders as the child will not be
held securely in a sharp turn, sudden stop,
or crash.
Fixed Back Infant Seat
The fixed seat back version of the Infant Seat
features three height adjustments for the
harness shoulder straps. The harness straps
must be used in the slots that position the
FEATURES
5.0
Knob handle must
be vertical
Fig. 29-1
Fig. 29-2
29