Harman The Accentra Pellet Stove Installation & Operating Manual page 11

ImPOrTANT NOTE: The Accentra is shipped bolted
to the skid through two holes in the cast base plate.
If these holes are not used to lag the unit to the floor
these holes must be filled with the 3/8" x 1/2" hex head
bolts provided. (See tag on bolt bag provided.)
Fig. 14
Skid bolt down holes/floor lag down holes
Optional rubber Pad leveling Feet
Optional kit #1-00-12302 contains 4 rubber pad feet.
Used to raise the bottom edge of the cast base plate
off the floor surface, they ensure that any vibrations
caused by motors and other moving parts will not be
transferred by direct contact. These rubber pads have
a threaded stud that extends through the base plate.
The top of the threaded stud has a screwdriver slot.
Therefore, the unit can be leveled from above inside
the unit. The front two are in the right and left front
corners of the firebox. NOTE: The door will need to be
partially closed to access the right leveling pad stud
due to the door hinge.
The rear two studs are to the right and left of the
distribution blower. They are somewhat difficult to
reach, therefore, it is suggested that the rear two pads
be adjusted by tilting the unit slightly forward. Adjust
the pads with your fingers and tilt unit back for fit. Then
adjust the front pads for the final clearance.
Leveling/vibration-dampening feet
Installation
There is a leg kit available for the Accentra (Item # 1-
00-247211). The four cast iron legs bolt to a plate, and
the stove then sits on the plate. The rubber leveling feet
are removed to allow the stove to fit down over the leg
plate. The leg kit adds 2.95 inches in height. The leg
kit can also be used in conjunction with the cast floor
protector. If using with the cast floor protector, a floor
protector cover is also needed since the legs allow
viewing underneath the stove.
dO NOT blOCK Or ObSTruCT ThE ArEA
bENEATh ThE APPlIANCE. ThIS AIrFlOw
IS CruCIAl TO SAFE OPErATION ANd
ClEArANCES TO COmbuSTIblES.
Fig. 15
Optional leg Kit
Leg Kit includes;
four legs, mounting
plate and hardware.
11