Advertisement
license plate. When choosing a wiring path, make sure the cable
will not be damaged or pinched, as this may cause a short circuit
that is not covered by the warranty. If drilling a hole, perform the
following steps:
a)
Acquire a 5/8 inch drill bit, rust preventive, all of which can be
purchased at a hardware store.
b)
Check behind the intended drilling location before drilling to
verify that no wires or mechanisms can interfere with or be
damaged during drilling.
c)
Check for interference with license plate lights and the hatch
release switch and/or mechanism.
d)
Drill a 5/8 inch hole at the selected location.
e)
Coat the edge of the hole with rust preventative.
f)
Route the camera cable through the grommet and then through
the hole.
g)
Insert the grommet in the hole to keep water from entering the
vehicle.
6. Assemble camera and mount on the vehicle.
6
Advertisement
