Advertisement
Quick Links
Features
•
Camera Fully Adjustable on all 3 Axis for off centre mounting.
•
Frame may be mounted above or below license plate.
•
High Resolution, ¼ inch CMOS Color Camera
•
Waterproof Housing
•
160 Degree Wide View Angle
•
Selectable Image: Normal/Reverse
•
12v – 24v
Model: CAM300/CAM310
Full or Partial
Frame Camera
Installation Manual
Advertisement
Related Manuals for Audiovox CAM300
Summary of Contents for Audiovox CAM300
- Page 1 Model: CAM300/CAM310 Full or Partial Frame Camera Installation Manual Features • Camera Fully Adjustable on all 3 Axis for off centre mounting. • Frame may be mounted above or below license plate. • High Resolution, ¼ inch CMOS Color Camera •...
-
Page 2: Table Of Contents
Table of Contents Warnings ..................3 Product Description ..............4 Packing List .................4 Camera Installation ..............5 Camera Wiring Diagram..............8 Specifications ................9 Troubleshooting ................9... -
Page 3: Warnings
2. You are responsible for ensuring that the installation of this product does not void or affect the vehicle manufacturer’s warranty. Audiovox Electronics Corporation or its subsidiaries are not liable in full or in part for improper installation resulting in loss or damage to your property, or for voiding all or part of the vehicle manufacturer’s... -
Page 4: Product Description
Product Description This fast and easy to mount back up camera allows you to use the license frame mounting bolts to securely attach a high quality, fully adjustable reversing camera. The camera is perfect for use on your car, truck, or van. This Wired Camera is designed for use with an Advent monitor but is compatible with most monitors/TFT screens and can be connected using a standard RCA connector. -
Page 5: Camera Installation
Camera Installation 1. Remove the rear license plate. 2. Examine the vehicle to determine the best way to run the power wires to the reverse lights and the extension cable through the car. 3. The Camera can be mounted above or below the plate. Determine the mounting location that best suits your needs. - Page 6 license plate. When choosing a wiring path, make sure the cable will not be damaged or pinched, as this may cause a short circuit that is not covered by the warranty. If drilling a hole, perform the following steps: Acquire a 5/8 inch drill bit, rust preventive, all of which can be purchased at a hardware store.
- Page 7 Wiring the Camera to the Vehicle’s Reverse Lamp 1. Locate the reverse lamp in the tail light assembly. 2. Using the tap connector supplied, perform the following steps: Place the un-stripped positive lead from the tail lamp in the run channel, which runs completely through the connector.
-
Page 8: Camera Wiring Diagram
image view, clip the blue jumper wire loop on the wiring cable (labeled “Mirror Selection” below) to change the camera image to normal. Secure the clipped wires with electrical tape. To change back to reverse image view, reconnect the blue wires and secure with electrical tape. Camera Wiring Note: If used with an Advent LCD Monitor such as LCD4WM or LCDM42 the camera power and signal will be provided through a single... -
Page 9: Specifications
Specifications 1. Voltage: DC9V-DC28V 2. Current: 50 mA 3. Signal System: NTSC 4. Image Sensor: ¼” CMOS Sensor 5. Horizontal Resolution: 480 lines 6. Viewing Angle: 160 degrees 7. Minimum Illumination: 0.7 Lux 8. Image Display: Selectable Normal/Reverse Image 9. Adjustable Viewing Angle 10. - Page 11 © 2008 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788...