Advertisement
Changing the Master codes:
Enter the Programming mode, Enter「＊000」Followed by the new 5 digit master
code→（beep）→enrolled→Enter 「#」 to exit from the programming mode, or
program other operating.
Master Code reset to Factory 「12345」
Insert the jumper P1
Insert the jumper to 2-3 position.
5. Wiring diagram:
Note:
The suggested wire gauge is #22~26 AWG.
The varistor or diode must be connected across the lock terminal (electromagnet...)
operated by the device. The vartistor controls the overload produced by the strike coil
(EMP).
Egresses switch should be N.O. type.
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG101 Ver. B Publish:2008.10.23
2-3 position 5 audible beeps Reset successful
Return
Page: 3/ 3
Advertisement
