Solving Operating Problems - Fisher & Paykel AeroXL Installation Instructions And User Manual

Solving operating problems

26
The following is a list of problems you may encounter when using this appliance and some
suggestions that may help to correct the problem. If you still have problems, please contact
your Fisher & Paykel Authorised Repairer.
Pressing POWER does not turn on the dryer
Is the electrical cord plugged into a power socket? If not plug the cord in.
If there is a power switch, is it switched on?
Could your household power supply be at fault? If your plug is suitable, try plugging another
electrical appliance into the same outlet.
Turn off the power at the power point. Unplug the dryer from the power socket. Wait 60 seconds,
plug it back in, turn it on and try again.
Check your house circuit breakers and fuses. If they are at fault contact an electrician.
Is the power cord damaged?
Dryer does not heat
Is the dryer set to the AIR DRY cycle?
Is the water tank full?
Has the dryer cycle progressed to COOL? Check the Progress lights, are the COOL and END lights
illuminated?
If the problem persists call for service.
Pressing START/PAUSE does not start the drying cycle
Did you touch START/PAUSE firmly enough?
Is the dryer paused? (the START/PAUSE light will be flashing).
Is the dryer door closed properly?
Is there a user warning or fault code displayed on the display panel? Refer to pages 24 and 25
for help.
Is the dryer making a beeping noise?
Is the water tank full? Is the water tank properly in place?
Has the lint filter been cleaned? Is the lint filter in place?
Has the dryer been overloaded?
Is DELAY START set?
Dryer keeps stopping and starting
Has WRINKLE FREE been selected? Refer to page 20.
Dryer stops working mid-cycle
Has there been a power failure? If so, press POWER and restart the desired cycle.
Has the dryer been paused?
Is the door open?