Table of Contents
Advertisement
7. Measure the width of the center seat area between the longitudinal seams.
NOTE: The width must be at least 10 inches (250 mm). The heating pad CANNOT
contact the side seems of the seat. If it does make contact, the seat heater cannot
be installed. Refer to Figure 3.
The SCO1, SCO2 and SSP1 are premium, pre-cut pads that are
designed to allow for quick installation on seats with vertical or
horizontal listings.
No cutting or taping required by the installer. If using one of
these models, proceed to step 11 and simply install following
the general installation instructions.
8. Position the heating pad with the label facing down and the wire harness
routed towards the back of the seat area. Adjust the pad so the thermostat
is located approximately 1-2 inches (25-50 mm) forward of the back rest. In
cases where the seat cushion contains lateral grooves (side to side) to allow
for trim cover attachment, a section of the heating pad will need to be cut out.
Refer to Figure 4.
6
Figure 3
Figure 4
Advertisement
Table of Contents
