Table of Contents
Advertisement
CAUTION: Do NOT cut the side of the heating pad.
11. Both heating pads must be connected to ensure system functions properly.
The SCO1, SCO2 and SSP1 are premium, pre-cut pads that are
designed to allow for quick installation on seats with vertical or
horizontal listings.
No cutting or taping required by the installer.
WARNING: Metal, electrical conductors or hog rings are not to be placed on,
through or across the heating element.
WARNING: Do not tap or solder seat heater harness to any airbag circuits. Yellow
tape, tubing and connectors will indicate airbag circuits.
WARNING: Do not tap or solder seat heater harness to any pre-loaded safety
belt circuits.
Installation Parts
Description
Seat Heater Pad
Wire Harness Assembly
Switch Assembly
Seat Cushion
1.
Prior to removing seat from vehicle, lay heating pads on seat to verify size and
fit.
2. Park and secure the vehicle on a level surface.
3. Disconnect the negative battery cable. If you have any doubt concerning the
layout of the vehicle wire harness, consult the wiring diagram provided by the
manufacturer.
4. Remove seat from vehicle and place on a suitable work table/area.
NOTE: Make certain to disconnect all wire connectors prior to removing seat from
vehicle.
4
Wire Ties
Quantity
2
1
1
8
Advertisement
Table of Contents
