Additional Lcd Remote Control Features - Code Alarm CA 671 Owner's Manual

Additional LCD Remote Control Functions
LCD Remote Control Display Illumination
Press and release the "F" button on the LCD remote control one time. The display will illuminate for 10 seconds.
LCD Remote Control Vibrate or Tones
Press and release the "F" button and the UNLOCK button on the LCD remote control simultaneously one time to
toggle between beep tones and vibrate mode. The LCD remote control will either beep or vibrate to indicate which
mode is selected.
Page Call Out
From within the vehicle, press and hold the emergency override button for 4 seconds, the LCD remote control will
emit a beep tone to indicate that someone is calling you to the vehicle.
Out of Range
If the LCD remote control is within operating range of the vehicle the antenna or IN-RANGE INDICATOR icon will
be displayed after any button is pressed. If this icon disappears after a button is pressed the vehicle is out of range
of the remote control.
Countdown Timer
The LCD remote control is equipped with a countdown timer for situations where an alert tone may be needed to
remind you of something important. The countdown timer allows you to set the timer up to 19 hours and 59 minutes.
Refer to page 9 for programming.
Parking Meter Timer
The LCD remote control is equipped with a parking meter timer that allows you to set a countdown timer for 10, 20,
30, 60, 90 or 120 minutes. The LCD remote control will emit a beep tone when the timer expires. Press "F" and
OPT simultaneously to select desired time.
Alarm Clock
The LCD remote control is equipped with a built in alarm clock that can be set to beep at a certain time each day.
The alarm clock must be set, and the feature turned on. Refer to page 10 for programming time. Press "F" and
TRUNK simultaneously to turn ON and OFF if the desired time has already been set.
Bypassing The Shock Sensor
There are 3 additional modes of operation in which your system will react to the shock sensor, FULL TRIGGER
ONLY, ALL OFF, or CITY MODE.
Press LOCK once to arm the system.
Pressing LOCK again within 2 seconds will set the system to FULL TRIGGER ONLY in which the system will
ignore the light touch setting.
Pressing LOCK again within 2 seconds will set the system to ALL OFF. In this mode the system will not react to
the shock sensor and the 2-way LCD remote will display the shock sensor icon.
Pressing LOCK again within 2 seconds will set the system to CITY MODE. In this mode the light touch horn output
is extended to a full 10 seconds and full trigger horn output is shortened to 15 seconds, no icon is displayed.
NOTE: The system will only change the shock sensor setting for one arm cycle and will be defaulted back to normal
operation the next time the system is armed.
8