Advertisement
After removing the two #0
point phillips screws
shown, pry the case apart
with the edge of a finger
nail or a small common
screwdriver. Keep hold of
the metal key ring loop to
prevent its loss as it will
separate from the transmit-
ter case.
Carefully remove the
discharged battery by
sliding it out from under the
clip in the direction indicated
by the arrow in the diagram
below. Properly dispose of
the exhausted battery and
insert a new CR2032
battery, taking care to
arrange it so that the + is
facing up toward the +
symbol on the battery
Reassemble in the reverse
of above.
6
128-8679
clip.
6 of 8
Advertisement
