Asus P4C800 User Manual page 54

9. ATX power connectors (20-pin ATXPWR, 4-pin ATX12V)
These connectors connect to an ATX 12V power supply. The plugs
from the power supply are designed to fit these connectors in only one
orientation. Find the proper orientation and push down firmly until the
connectors completely fit.
In addition to the 20-pin ATXPWR connector, this motherboard requires
that you connect the 4-pin ATX +12V power plug to provide sufficient
power to the CPU.
1. Do not forget to connect the 4-pin ATX +12V power plug.
2. Make sure that your ATX 12V power supply can provide 8A on the
®
P4C800
P4C800 ATX Power Connector
2-28
Otherwise, the system does not boot up.
+12V lead and at least 1A on the +5-volt standby lead (+5VSB).
The minimum recommended wattage is 230W, or 300W for a fully
configured system. The system may become unstable or may not
boot up if the power is inadequate.
ATX12V1 ATXPWR1
GND +12V DC
+3.3VDC
-12.0VDC
GND
PS_ON#
GND
GND +12V DC
GND
GND
-5.0VDC
+5.0VDC
+5.0VDC
Chapter 2: Hardware information
+3.3VDC
+3.3VDC
GND
+5.0VDC
GND
+5.0VDC
GND
PWR_OK
+5VSB
+12.0VDC