Trim Presets (Zones A) - McIntosh MHT200 Owner's Manual

MENU: SOURCE SETTINGS
1. SOURCE INPUT
2. TITLE
3. DIGITAL INPUT
4. COMPONENT INPUT
5. INPUT LEVEL
6. TRIM PRESETS
7. TRIM PRESET SETUP
EXIT
select the PRESET Number 1.
25. Using the Up or Down
select one of the TRIM SELECT volume or tone set-
ting.
26. Using the Left or Right
to adjust up or down the setting.
Note: The range of adjustment is ±12 dB.
27. If there are any additional TRIM PRESETs to be en-
tered at this time repeat steps 24 through 26.
28. Using the Up or Down
select EXIT.
Trim Presets
In the following steps the Trim Presets just entered above
will be assigned to different inputs. Refer to figure 36 and
37.
29. Using the Up or Down
select SOURCE INPUT from the On-Screen Menu,
followed by pressing the Left
push-buttons to select the DVD Input, Number 5.
30. Using the Up or Down
select TRIM PRESETS on the On-Screen Menu.
31. Using the Left or Right
to select the PRESET Number 1.
Note: The Trim Preset choices include: NO CHANGE,
FLAT, 1, 2, 3, 4 OR 5.
32. If there are any additional Source Inputs to have a
Trim Preset assigned to it at this time, repeat steps 29
through 31.
33. Select EXIT on the menu and the MAIN SYSTEM
6
VCR1
Opt C
1
No Change
Figure 35
directional push-buttons
directional push-buttons
directional push-buttons
directional push-buttons
or Right directional
directional push-buttons
directional push-buttons
MENU: SOURCE SETTINGS
1. SOURCE INPUT
2. TITLE
3. DIGITAL INPUT
4. COMPONENT INPUT
5. INPUT LEVEL
6. TRIM PRESETS
7. TRIM PRESET SETUP
EXIT
MENU: PRESET SETUP
1. PRESET
2. TREBLE
3. BASS
4. CENTER
5. SURR
6. SUB
EXIT
SETUP Menu will reappear on the Monitor/TV
screen.
34. Continue next to the VIDEO POWER CONTROL. If
you do not wish to perform VIDEO POWER CON-
TROL Adjustments at this time, proceed to the next
step.
35. Select EXIT from the MAIN SYSTEM SETUP
Menu. If you are satisfied with the changes that you
may have made, select YES to save those changes or
NO not to save them. The MHT200 will then return to
normal operation. Refer to figure 13 on page 25.
SETUP, con't
6
VCR1
Opt C
1
No Change
Figure 36
1
+ 0dB
+ 0dB
+ 0dB
+ 0dB
+ 0dB
Figure 37
39