Honeywell ADEMCO VISTA-12A User Manual page 15

3. Enter the desired 2-digit event number from the following list.
00 = remove the scheduled event
01 = turn a programmed device on or off
02 = set a user access schedule for one or more users)
03 = send "child-not-home" report; see Child Not Home notes below
04 = automatically arm the system in STAY mode at a specified time (cannot be used if a common area
exists)
05 = automatically arm the system in AWAY mode at a specified time (cannot be used if a common area
exists)
06 = automatically disarm the system at a specified time
07 = Display the word "REMINDER" at a specified time
08 = Disarm Time Window (system can be disarmed only during this time period; Exception: if a burglary
alarm occurs, the system can be disarmed outside the scheduled time window)
Press [∗] to continue.
4. For event number "01," enter the 2-digit output number (01-04, 17-18)
associated with this schedule. Otherwise, this prompt is skipped.
Press [∗] to continue to the "Start" prompt below.
5. For event number "02," enter the 1-digit access group number (1-8).
Otherwise, this prompt is skipped.
Press [∗] to continue to the "Start" prompt below.
6. For event numbers "03-08," enter the partition number to be armed or
disarmed. Otherwise, this prompt is skipped.
0 = arm all; 1 = partition 1; 2 = partition 2; 3 = common partition
Press [∗] to continue to the "Start" prompt.
7. Enter the event's start time and days of week: Hour = 00-23; minute = 00-
59
Days = Position the cursor under the desired days using the [∗] key to
move forward, then press "1" to select the day(s).
Press [∗] to continue.
8. For events 04 or 05, enter the desired amount of time, 01-15 minutes, the
system should warn of impending arming. The system beeps once every 30
seconds to alert users that arming will soon occur. Otherwise, prompt is
skipped.
Press [∗] to continue.
9. Enter the event's stop time and days of week. Refer to step 7 for available
entries.
Press [∗] to continue.
10. Enter the desired repeat option.
0 = no repeat; 1 = repeat schedule weekly
2 = repeat schedule biweekly (every other week)
3 = repeat schedule every third week; 4 = repeat schedule every fourth
week
e.g., To make a schedule that happens everyday you would select all days
with a repeat count of 1.
NOTE: Schedules run sequentially from Sunday to Saturday and reset on
Sunday at midnight. If repeat count is 0, only those events scheduled from
the day the schedule is set to Sunday will occur. Events scheduled after
Sunday will be ignored.
Creating Schedules (cont'd)
ENTER EVENT
DEVICE NUMBER
XX
GROUP NUMBER
X
PARTITION
X
START SMTWTFS
HH:MMAM 1000000
WARNING DELAY TIME
00
STOP SMTWTFS
HH:MMAM 1000000
REPEAT OPTION
0-4 X
– 15 –