Cumberland Stove Works MF3800 Installation And Service Manual page 4

WARNINGS AND SAFETY PRECAUTIONS
• Before cleaining or performing
• The stove will not operate during
• This stove must be connected
• Do not place clothing or other
• Ardisam, Inc., grants no warranty,
Page 4
FOR QUALIFIED INSTALLERS ONLY
any service to your stove, ensure
the stove has had time to cool.
Ashes should be disposed of in
a metal container with a tight lid
and placed on a non-combustible
surface well away from the home
or structure.
a power outage. Do not unplug
the stove. The stove will return
to range screen and must be
reignited.
to a standard 115 V., 60 Hz
grounded electrical outlet. Do
not use an adapter plug or sever
the grounding plug. Do not route
the electrical cord underneath, in
front of, or over the stove.
flammable items on or near the
stove. Because this stove can be
controlled by a thermostat there
is a possibility of the stove turning
on and igniting any items placed
on or near it.
implied or stated, for the
installation or maintenance
of your stove, and assumes
no responsibility of
consequential damage(s).
CumberlandStoveWorks.com
INSTALLATION AND SERVICE MANUAL
any
Model MF3800
• The exhaust system should be
checked twice a year minimum
for any build-up of soot or
creosote. Contact a servicing
dealer for assistance.
• Disconnect the power cord before
performing any maintenance.
NOTE: Turning the Mode Switch
to "OFF" does not disconnect all
power to the heater.
• Do not throw this manual away,
as it contains important operating
and maintenance instructions
that you will need at a later time.
Always follow the instructions in
this manual.
• Do not touch the hot surfaces of
the stove. Educate all children of
the danger of a high-temperature
stove. Young children should be
supervised when they are in the
same room as the stove.
• This stove is approved for mobile
h o m e s . Ac c o r d i n g t o H U D
(Housing & Urban Development)
requirements, when installed in
a mobile home, this stove must
be grounded directly to the steel
chassis of the mobile home and
bolted to the floor. Direct air access
must be provided—use a Fresh Air
Kit. The structural integrity of the
mobile home floor, wall, and ceiling/
roof MUST BE maintained.