Mounting The Controller, Installing Remote Thermostat, Mounting The Door And Adjusting Door Latch; Installing Remote Thermostat; Latch Adjustment - Cumberland Stove Works MF3800 Installation And Service Manual

MOUNTING THE CONTROLLER
The CSW MF Series Stove has three different controller
mounting options:
1. Back of the stove with controller visible: You may mount the
controller on either side of the rear of the stove (FIGURE
6A) so it is visible during operation. To do so, use the metal
mounting bracket and the four (4) self-tapping screws (two
(2) through the plastic bracket and two (2) through the back
panel of the stove). Attach through the pre-drilled holes.
Note: Self-tapping screws must penetrate hopper.
2. Back of the stove with controller hidden: You may mount the
controller on either side of the stove (FIGURE 6B) so it is
not visible during operation. Attach the plastic mounting
bracket to the pre-drilled holes on either side of the stove
using the (2) self-tapping screws.
Note: Self-tapping screws must penetrate hopper.
3. Wall mounted (FIGURE 8): You may mount the controller
on the wall next to the unit using two drywall screws. It is
best to embed the screws into a stud. Use a stud finder to
locate studs in the wall.

INSTALLING REMOTE THERMOSTAT

The MF Parlor Stove can be run thermostatically by purchasing
any thermostat (sold separately) that uses a mechanical switch.
This step is optional and not required for MF Parlor Stove to
operate.
Mount thermostat according to manufacturer specifications.
Using a small flat head screwdriver, tighten remote thermostat
wires into pins 7 and 8. SEE FIGURE 9.
PLUG STOVE INTO CONTROLLER
After mounting the controller, plug the phone cord from the
back of the stove to the underside of the controller.
MOUNT DOOR
Take off protective cardboard. Hang door on hinges making
sure it's seated properly so the latch is aligned with the latch
cut-out.

LATCH ADJUSTMENT

The door gasket may settle after use. Adjustment to the latch
is necessary to ensure proper seal. To adjust the latch, remove
the roll pin and swap washers from the inside of door to the
outside of the door. Replace roll pin and inspect door fit. SEE
Figure 8.
Page 10
FOR QUALIFIED INSTALLERS ONLY
CumberlandStoveWorks.com
INSTALLATION AND SERVICE MANUAL
Figure 6a: Controller on metal
bracket in back.
Figure 7: Controller on wall.
Figure 9: Remote Thermostat Terminals
Model MF3800
Figure 6b: Controller on plastic
bracket in back.
Figure 8: Door Latch Adjustment.
remote
thermostat
terminals