Krell Industries DT-10 Owner Reference Manual page 16

OPEI &TION
DIM: Shuts off the display and function LEDs. Second press activates the
display and function LEDs.
A/B: The DT-10 can make a loop between two set times within a track. This
is helpful when you need to repeat a specific segment of a track.
To create an A/B loop:
Start play of track. Press A/B to insert the start position. Press A/B again
to insert finish position. A/B will automatically begin. Press Stop to delete
A/B program.
ACCESS: The Access function gives you the ability to numerically select a
position within a specific track program. This is valuable when exact start
positions are critical.
To go to a specific time on a disc:
1. Press access. Two zeros will show on the display.
2. Enter a two digit track number, then press Program.
3. Enter a two digit minute number, then press Program.
4. Enter a two digit second number, then press Program. The track will be-
gin play at the designated time.
EXAMPLE: Here is a program sequence for Access number 02.01.11
1. Press Access
2. Press 02 then Program
3. Press 01 then Program
4. Press 11 then Program
Track 2 will begin play at 1 minute and 11 seconds into the piece.
NOTE: When entering an access number, remember not to exceed the track's
playing time while programming. When this occurs the DT- 10 will default to
the total disc playing time and your access number will not be acknowledged.
PAGE 16