Table of Contents
Advertisement
32 Service Search
3.3 Editing the transponder list
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Choose your desired transponder at the Frequency op-
tion.
3. Change the Polarization option to match to that of your
desired transponder.
4. Set the Modulation option to match to that of your de-
sired transponder. If the transponder is of the DVB-S2
standard, you should set this option to DVB-S2 QPSK or
DVB-S2 8PSK. Then the FEC option and the Pilot option
will become enabled. You also should set these options
correctly.
5. To change a satellite entry's name, select your desired
entry at the Satellite Name option and select the SAT
Name Edit option. Then the on-screen keyboard ap-
pears. Change the name and save it. See
to use the on-screen keyboard.
6. Select the Save option and press the
the changes. To stop at any time or to exit without saving,
£
¢
press the
EXIT
If you failed to receive services of
a transponder because it consists
of wrong data, you can solve it
by correcting the data. Select the
Installation > SAT/TP Edit menu.
To change the data of a trans-
ponder, take the following steps:
¡
button.
§6.3
as to how
£
¢ ¡
button to save
OK
Advertisement
Table of Contents
