Pliance - Zanussi ZDT11001 User Manual

German
degrees
(°dH)
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
Manual adjustment
1
E E lectronic adjustment
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press and hold the programme button until the pro-
gramme indicator (A A ) flashes and the programme in-
dicator (B B ) comes on.
4. Wait until the programme indicator (B B ) goes off and
the end indicator starts to flash (the programme indi-
cator (A A ) continues to flash).
5. Press the programme button.
• The end indicator flashes intermittently. The num-
ber of flashes shows the level of the water softener.
Example: 5 flashes + pause + 5 flashes = level 5.
6. To adjust the level of the water softener, press the
programme button. Each time you press the pro-
gramme button you go to the next level.
7. Deactivate the appliance to confirm.
1 1 8
Water hardness
French
degrees
(°fH)
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7
2
Turn the water hardness
dial to the position 1 or 2.
mmol/l Clarke
degrees
13 - 17
5 - 12
< 0.7 < 5
Filling the salt container
Caution! Only use dishwasher salt. Other products
can cause damage to the appliance.
Water and salt can come out from the salt container when
you fill it. Risk of corrosion. To prevent it, after you fill the
salt container, start a programme.
1
3
Put 1 litre of water in the
salt container (only for the
first time).
Water softener
adjustment
Manual Electronic
1 3
1 2
2) 2)
1 1
2
4