Table of Contents
Advertisement
Printer Firmware Revision
The Firmware of your HP LaserJet printer must be the following Revision to correctly support the TowerFeed
option:
HP LaserJet 8150
HP LaserJet 8100
HP LaserJet 8000
> 4.29
In case your HP LaserJet 8000 printer does not have a newer printer Firmware revision than 4.29, you have to set
the POWERSAVE function to OFF (printer panel: CONFIGURATION MENU, POWERSAVE = OFF) or ask your HP
Dealer for a newer printer firmware.
Printer Driver Revision
Please use the drivers from the CD received with your printer.
For the most recent driver revisions available, please consult the HP WEB or our WEB site at
http://www.rutishauser.ch/ti/sdlhp.htm.
HP LaserJet Duplexer Option
The printer's duplexing capabilities remain fully supported, with the TowerFeed paper handling option installed.
HP 2000-Sheet Tray and 2x500-Sheet Input Trays
TowerFeed is used instead of these options and therefore, they cannot be installed together with TowerFeed.
Optional HP Paper Output Units
These output options can be installed together with TowerFeed. For the TowerFeed 6-tray unit you can order a
special stand to compensate for the height difference of the output option.
HP JetAdmin
The HP JetAdmin network printer administration software does not fully support the TowerFeed paper handling
option, particularly not the remote paper type assignment to the paper trays. (This assignment has to be done via
the printer panel, as described in Papertype Assignments on page 9 of this manual.)
IU 660 / 0047
all revisions
5.29 or newer
(lower firmware revisions do not support the 'POWESAVE' function)
APPENDIX A - Printer Specific Notes
TM
15
TowerFeed
for the HP LaserJet 8150/8100/8000
Advertisement
Table of Contents
