Troubleshooting - Exmark FMD524 Operator's Manual

Troubleshooting

Important: It is essential that all operator safety mechanisms be connected and in proper operating
condition prior to mower use.
When a problem occurs, do not overlook the simple causes. For example: starting problems could be caused
by an empty fuel tank.
The following table lists some of the common causes of trouble. Do Not attempt to service or replace major
items or any items that call for special timing of adjustments procedures (such as valves, governor, etc.). Have
this work done by your Engine Service Dealer.
Note: When disconnecting electrical connectors Do Not pull on the wires to separate the connectors.
Problem
Uneven cutting height.
Abnormal vibration.
Blades do not rotate.
Possible Cause
1. Blade(s) not sharp.
2. Cutting blade(s) is/are bent.
3. Mower deck is not level.
4. Underside of mower is dirty.
5. Tire pressure in drive tires not correct.
6. Blade spindle bent.
7. Tips of adjacent blades are at an uneven
cutting height. Blades tips should be even
within 3/16 inch which is approximately
one blade thickness.
1. Cutting blade(s) is/are bent or unbalanced.
2. Blade mounting bolt is loose.
3. Engine mounting bolts are loose.
4. Loose engine pulley, idler pulley, or blade
pulley.
5. Engine pulley is damaged.
6. Blade spindle is bent.
7. Belt is damaged.
1. Drive belt is worn, loose or broken.
2. Drive belt is off pulley.
3. Deck belt is worn, loose or broken.
4. Deck belt is off pulley.
5. Broken or missing idler spring.
17
Troubleshooting
Corrective Action
1. Sharpen the blade(s).
2. Install new cutting blade(s).
3. Level mower deck from side-to-side and
front-to-rear.
4. Clean the underside of the mower.
5. Adjust tire pressure in the drive tires.
6. Contact an Authorized Service Dealer.
7. Replace blades, spindles and (or) check
for damage to mower deck.
1. Install new cutting blade(s).
2. Tighten the blade mounting bolt.
3. Tighten the engine mounting bolts.
4. Tighten the appropriate pulley.
5. Contact an Authorized Service Dealer.
6. Contact an Authorized Service Dealer.
7. Install new belt.
1. Check the belt tension.
2. Check belt for damage; replace if
necessary. Install drive belt and check
adjusting shafts and belt guides for correct
position.
3. Install new deck belt.
4. Install deck pulley and check the idler
pulley, idler arm and spring for correct
position and function.
5. Replace the spring.