Cisco ATA 190 Administration Manual page 26

Adding the ATA 190 to the Cisco Unified Communications Manager Database
Adding the ATA 190 with Auto-Registration
By enabling auto-registration before you begin installing the ATA 190, you can:
•
•
•
•
Auto-registration is disabled by default. In some cases, you may not want to use auto-registration; for
example, if you want to assign a specific directory number to the phone or if you plan to use secure
connection with Cisco Unified Communications Manager as described in Cisco Unified
Communications Manager Security Guide. For information about enabling auto-registration, see the
Enabling Auto-Registration in the Cisco Unified Communications Manager Administration Guide.
Note When you configure the cluster for mixed mode through the Cisco CTL client, auto-registration is
automatically disabled. When you configure the cluster for nonsecure mode through the Cisco CTL
client, auto-registration is not automatically enabled.
Related Topics
Adding the ATA 190 with Cisco Unified Communications Manager Administration, page 2-6
Adding the ATA 190 with Cisco Unified Communications Manager
Administration
You can add the ATA 190 individually to the Cisco Unified Communications Manager database using
Cisco Unified Communications Manager Administration. To do so, you first need to obtain the MAC
address for each device.
For information about determining a MAC address, see
page
After you have collected MAC addresses, in Cisco Unified Communications Manager Administration,
choose Device > Phone and click Add New to begin.
The first device used the MAC address and the second device uses the shifted MAC address (example,
Note
AABBCCDDEEFF to BBCCDDEEFF01). You can add two devices from the Unified CM administration
page.
For complete instructions and conceptual information about Cisco Unified Communications Manager,
see the Cisco Unified Communications Manager Administration Guide and the Cisco Unified
Communications Manager System Guide.
Cisco ATA 190 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
2-6
Add devices without first gathering MAC addresses from the ATA 190.
Automatically add a ATA 190 to the Cisco Unified Communications Manager database when you
physically connect the phone to your IP telephony network. During auto-registration, Cisco Unified
Communications Manager assigns the next available sequential directory number to the phone.
Quickly enter devices into the Cisco Unified Communications Manager database and modify any
settings, such as the directory numbers, from Cisco Unified Communications Manager.
Move auto-registered devices to new locations and assign them to different device pools without
affecting their directory numbers.
2-7.
Chapter 2 Preparing to Install the ATA 190 on Your Network
Determining the MAC Address of an ATA 190,
OL-31821-01