Conventional Operation; TurnNg Power On; Channel SelectOn - Icom IC-F51 Instruction Manual

CONVENTIONAL OPERATION

■ Turning power ON
q Rotate [VOL] to turn power ON.
w If the transcever s programmed for a start up passcode, nput
dgt codes as drected by your dealer.
• The keys n the table below can be used for password nput:
• The transcever detects numbers n the same block as dentcal.
Therefore "01234" and "56789" are the same.
KEY
NUMBER
e When the "PASSWORD" ndcaton does not clear after nput-
tng 4 dgts, the nput code number may be ncorrect. Turn the
power off and start over n ths case.
■ Channel selection
Several types of channel selectons are avalable. Methods may
dffer accordng to your system set up.
NON-BANK TYPE:
Push [ ]/[
quence; or, push one of the [MR-CH 1] to [MR-CH 4] keys to se-
lect a channel drectly.
BANK-TYPE:
Push [Bank], then push [
AUTOMATIC SCAN TYPE:
Channel settng s not necessary for ths type. When turnng the
power ON, the transcever automatcally starts scannng. Scannng
stops when recevng a call.
0 1
5 6
] to select the desred operatng channel, n se-
]/[
2 3
7 8
] to select the desred bank.
3
2
3
4
9
12