Advertisement
Open the cover of the ink vehicle
Put out the original cartridges
3. Installation of the support arm
We have installed the support
arm in the cartridges
Close the tubes to the support arm by clasp, and make sure the tubes are not contorted
4、Adjust he tubes
Pull out the power wire, then move
the Ink vehicle
Move the ink vehicle to the left,
whether there is baffle
Put in the cartridges of CISS
Put another short support arm in the
middle of groove
move it to the left end
In the same way, move it to the right installation finished
, whether it will hit anywhere
Cover the lid and make sure the
cartridges are in the right position
Put the long support arm 3.5cm right to
the short one and 10cm down.
pull the tubes straight, the tube can not
be that long or contorted.
Advertisement
