Wolf CT30I/S Use & Care Manual page 12

Induction Cooktop Operation
Cooktop Operation
HI-POWER MODE
Hi-Power mode boosts power on one induction element
by diverting power from an adjacent element. This mode is
suitable for frying foods or boiling water rapidly.
To activate Hi-Power mode, touch the OFF ON touch pad
for the element you wish to use. Then touch HI-POWER.
Power from an adjacent element will automatically be
diverted to the element. If the adjacent element is on HIGH
power, the power output will be reduced. This reduction in
power will be displayed in the power bar indicator of the
adjacent element.
HI-POWER
TOUCH PAD
Hi-Power mode (CT36I/S
shown).
HOT SURFACE INDICATOR
As a safety precaution, a hot-surface indicator light will
illuminate when the surface temperature of any one of the
induction elements rises above 150°F
illuminate in the control panel display. It will remain illumi-
nated until the entire surface temperature has lowered to a
safe level, even after the cooktop controls are turned off.
TIMER OPERATION
The induction cooktop features a countdown timer located
in the control panel. Refer to the illustration below.
The timer may be set in one-minute increments up to 99
minutes. Once set, the remaining time will be illuminated in
the control panel as it counts down. The timer can be used
anytime the cooktop is not in lock mode.
• To start the timer, touch
+ –
and hold or until the desired time is shown in the
timer display. The timer will begin its countdown in
minutes, 3 seconds after the time is set.
• A warning chime will sound when the timer has one
minute left and begins to countdown in seconds.
• When the timer reaches 0, an audible chime will sound.
The chime will continue to sound every 30 seconds
until CLEAR is touched.
HOT-SURFACE
INDICATOR LIGHT
Hot-surface indicator.
. 'HOT' will
(65°C)
+
on the timer control. Touch
+
AND
TOUCH PADS
CLEAR
TOUCH PAD
Timer control.
12
–