Peavey AAM 802 User Manual
  1. Manuals
  2. Brands
  3. Peavey Manuals
  4. Music Mixer
  5. AAM 802
  6. User manual
Peavey AAM 802 User Manual

Peavey AAM 802 User Manual

Compact console
Hide thumbs Also See for AAM 802:

Advertisement

Table of Contents

TM
AAM
802/1602
User Manual

Advertisement

Table of Contents
loading

Related Manuals for Peavey AAM 802

Summary of Contents for Peavey AAM 802

  • Page 1 802/1602 User Manual...
  • Page 2 ATTENTION: Afin de réduire le risque de choc électrique, ne pas enlever le couvercle. Il ne se trouve à l’intérieur aucune pièce pouvant être reparée par l’utilisateur. Confiez I’entretien et la réparation de l’appareil à un réparateur Peavey agréé. AVERTISSEMENT: Afin de prévenir les risques de décharge électrique ou de feu, n’exposez pas cet appareil à la pluie ou à...

  • Page 3: General Description

    ™ 802/1602 Compact Console The all new AAM 802/1602 Series mixer is a compact unit that can be used in sound reinforcement or recording applications. Its low noise design and extensive list of features make it the ideal mixing console for almost any application.

  • Page 4: Inputs And Outputs

    INPUTS AND OUTPUTS You must first connect your AAM 802/1602 to outboard equipment in order to better understand the remaining functions. This section describes the inputs and outputs found on the rear of the AAM 802/1602 mixer. The channel inputs are found in the “Input Channels” section of this manual in order to help you understand the internal signal flow of your AAM 802/1602 mixer.

  • Page 5: Master Section

    It is important that this area of the board be set up properly in order to get the most from the Input Channel Section of your AAM 802/1602. Warning: Keep all faders at the lowest position until you are ready to set your final levels.
  • Page 6 HEADPHONE OUTPUT: This stereo jack (TRS) provides the signal to drive stereo headphones. The level is set by the Headphone Level control (17). Tip= Left, Ring= Right, Shield= Ground. HEADPHONE/PFL LEVEL: Adjusts the level of the Headphone Output. The source changes from the L-R output to the PFL mix whenever the PFL is active.
  • Page 7 LED METERS: Two 12-segment LED arrays monitor the levels of the main L/R outputs. The 0 dB reference level corresponds to +4 dBu at the 1/4" jacks and XLR. (See 8.) MONITOR PEAK LED: Indicates that the monitor mix level is nearing the overload point.

  • Page 8: Input Channels

    +/-15 dB. On the first six channels of the AAM 802/1602, first 14 channels - AAM 802/1602), the frequency of the boost or cut is set by the Mid Frequency control (43). The other channels have a fixed frequency of 850 Hz.
  • Page 9 LOW EQ: A shelving type of active tone control that varies the bass frequency levels +/-15 dB at 70 Hz. It will add depth to thin signals or clean up muddy ones. MON 1: Adjusts the level of the channel signal (pre-EQ) that is added to the Monitor 1 mix. This is a mono mix of the left and right signals in the stereo channels.

  • Page 10: Stereo Inputs

    The optimum setting is the “0” (unity gain) position. Channel Functions 5 & 6 for AAM 802 and 13 & 14 for 1602: In these two channels all controls are identical to the previous channels with the exception of the insert jack.
  • Page 11 AAM 802/1602 COMPACT CONSOLE Specifications: Input Specifications: Function Input Z Input Gain Input Levels Bal/ Connector (ohms) Settings Min** Nominal* UnBal. Microphone 2.2 k Max. Gain -74 dBu -54 dBu -37 dBu Bal. XLR: Pin 1 Gnd, (150 ohms) (58 dB) Pin 2 (+), Min.

  • Page 12: Output Specifications

    Output Specifications: Function Minimum Output Level Bal/ Connector Load UnBal. Ohms Min** Main L/R +4 dBu +22 dBu Bal. 1/4" TRS: Tip (+), Ring (-) Sleeve Ground +4 dBu +22 dBu Bal. XLR: Pin 1 Ground Pin 2 (+), Pin 3 (-), (Bal.) Monitors +4 dBu +22 dBu...

  • Page 13: Hum And Noise

    Gain: Mic Input Gain Adjustment Range: 10 dB to 58 dB Mic Input to L/R Balance Output 78 dB (Max. Gain) Mic Input Longest Path 93 dB (Max. Gain) Line Input Gain Adjustment Range: -10 dB to 38 dB Line Input to L/R Bal. Output 60 dB (Max.
  • Page 14 Red LED lights 2 dB below clipping Dimensions (H x W x D): AAM 802: 5.500" x 15.000" x 16.500" (13.97 cm x 38.10 cm x 41.91 cm) AAM 1602: 5.500" x 23.000" x 16.500" (13.97 cm x 58.42 cm x 41.91 cm) Weight: AAM 802: 13.7 lbs.
  • Page 16 NOTES:...
  • Page 17 NOTES:...

  • Page 18: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed, including the following: Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. For example, near or in a bathtub, swimming pool, sink, wet basement, etc. Clean only with a damp cloth.
  • Page 19 What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges.
  • Page 20 Features and specifications subject to change without notice. Peavey Electronics Corporation • 711 A Street • Meridian • MS • 39301 (601) 483-5376 • FAX (601) 486-1678 • http://.aapeavey.com ©2001 Printed in the U.S.A. 4/01 80304861...

This manual is also suitable for:

Aam 1602

Table of Contents