Fisher & Paykel E402B Installation Instructions And User Manual page 10

Installation instructions
8
Contents of filter kit
4 m (13 ft) white 6 mm (¼") tubing
1
1 x 200 mm (8") blue tubing
2
1 x pressure reducing valve (PRV)
3
1 x double sided foam
4
2 x locking keys
5
1 x water filter cartridge and head
6
1 x tap connection – 15 mm (½") BSP
7
1
Important!
It is imperative the pressure reducing valve (PRV) is fitted prior to the filter. This valve ensures
■ ■
water will not flow back into the mains from the refrigerator's water system. If the PRV is not
fitted to the connection line, the Ice & Water features may not function in some circumstances.
The water connection to your Ice & Water refrigerator must be installed by an authorised
■ ■
plumber or authorised Fisher & Paykel service person.
The water connection instructions below are intended only for the professional installer.
■ ■
The new tubings supplied with the refrigerator are to be used, old tubings from old Ice & Water
■ ■
connections should not be used.
Installation precautions/warning
DO NOT use with water that is microbiologically unsafe or of unknown quality without
■ ■
adequate disinfection before or after the system.
WARNING – connect to potable water supply only.
■ ■
DO NOT install on line pressure above 827 kPa (119 psi) or below 150 kPa (22 psi).
■ ■
DO NOT use on hot water supply (38°C [100°F max.]).
■ ■
DO NOT cut any length of tube shorter than 200mm.
■ ■
DO NOT install near electrical wires or water pipes that will be in the path of drilling when
■ ■
selecting the location of the filter system.
DO NOT mount the filter in such a position that it will be struck by other items, such as
■ ■
wastebaskets, etc.
DO NOT install the filter or any water tubing in direct sunlight as prolonged exposure to light
■ ■
can weaken plastic components.
DO NOT install the filter in a location that is susceptible to freezing temperatures as damage to
■ ■
the filter housing could occur.
DO NOT screw the filter to the refrigerator.
■ ■
DO NOT install the filter or any water tubing in high temperature areas eg in a ceiling cavity.
■ ■
AVOID contamination of pipes during installation.
■ ■
DO NOT use copper tubing. The plastic tubing supplied should always be used.
■ ■
DO NOT continuously dispense water for a period longer than 2 minutes.
■ ■
2 3
Fig.2 Water connection kit
4 5 6 7