Operation - Using The Water Pump Wheel Kit; Specifications - North Star M109172B Owner's Manual

Operation – Using the Water Pump Wheel Kit
Step One: Inspect/Repair
If the water pump wheel kit has been used previously, it must be prepared BEFORE EACH
SUBSEQUENT USE.
Read instructions below carefully for inspecting and preparing the water pump wheel kit.
Damaged or missing components could result in injury to the operator or bystanders.
Important safety rules:
Replacement parts. If a part needs replacement, only use parts that meet the manufacturer's

specifications. Replacement parts that do not meet specifications may result in a safety hazard or
poor operation of the water pump wheel kit.
1. Review safety
information
2. Inspect & repair
3. Transport
Recommended Tire Pressure
Overall Dimensions (boxed)
Weight
The manufacturer reserves the right to make improvements in design and/or
changes in specifications at any time without incurring any obligation to install
them on units previously sold.
Any Questions, Comments, Problems or Parts Orders
Call North Star Product Support 1-800-270-0810
WARNING
Review the "Important Safety Information" section provided in this
manual.
Inspect and test the water pump wheel kit thoroughly
a. Check Tires for proper pressure level.
b. Check to be sure that all nuts and bolts are tight.
Grab the grip on the handle of the wheel kit and PULL the water pump
to desired location.
DO NOT PUSH the water pump as injury to the operator could result.

Specifications

109172 – Water Pump Wheel Kit
14 PSI
22"L x 12"W x 6" H
14 lbs
9