GE 20 Owner's Manual And Installation Instructions page 13

Ge side by side refrigerators
Table of Contents

Advertisement

Available languages

Available languages

CONNECT THE TUBING TO THE
7
REFRIGERATOR
Some models have the refrigerator connection at
the end of tubing located outside the compressor
compartment access cover. On other models,
the compressor compartment access cover must
be removed in order to access the refrigerator
connection at the water valve.
On models using the refrigeration connection at the
water valve, remove the plastic flexible cap.
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown. On a GE
SmartConnect
Refrigerator Tubing kit, the nuts
are already assembled to the tubing.
Insert the end of the tubing into the refrigerator
connection as far as possible. While holding the
tubing, tighten the fitting.
For plastic tubing from a GE SmartConnect
Refrigerator Tubing kit, insert the molded end of the
tubing into the refrigerator connection and tighten
the compression nut until it is hand tight, then tighten
one additional turn with a wrench. Overtightening
may cause leaks.
Fasten the tubing into the clamp provided as shown
to keep it in position. You may need to pry open the
clamp.
One of the illustrations below will look like the
connection on your refrigerator.
Tubing
Clamp
1/4
Compression
Nut
Ferrule
(sleeve)
Refrigerator
Connection
Installation Instructions
(CONT.)
1/4
Tubing
SmartConnect™
Tubing
CONNECT THE TUBING TO THE
7
REFRIGERATOR
Tubing
Clamp
Ferrule
(sleeve)
Refrigerator
Connection
TURN THE WATER ON AT THE
8
SHUTOFF VALVE
Tighten any connections that leak.
Reattach the access cover.
PLUG IN THE REFRIGERATOR
9
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
START THE ICEMAKER
10
Slide the icemaker power switch to the ON position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below.
It will then begin operation automatically if the
icemaker power switch is in the ON position.
13
(CONT.)
1/4
Compression
1/4
Nut
Tubing
SmartConnect™
Tubing
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

2225

Table of Contents