CLEANING & MAINTENANCE
IMPORTANT
•
The cooler is supplied with Honeycomb Cooling Media.
•
The cleaning frequency for the Honeycomb Cooling Media depends on local air and
water conditions. In areas where the mineral content of water is high, mineral deposits may build
up on the Honeycomb Cooling Media and restrict air flow. Draining the water reservoir and refilling
with fresh water at least once a week will help reduce mineral deposits. If mineral deposits remain
on the Honeycomb Cooling Media, it should be removed and washed under fresh water. The
Honeycomb Cooling Media should be cleaned every two months or sooner, depending on your
needs.
•
Do not run the unit in COOL mode with stale water in the tank. It is recommended to empty the
tank and refill it with fresh water if the water has been standing in the tank for an extended period
of time.
•
For best results, allow the Honeycomb Cooling Media to dry after each use by turning off the cool
function 15 minutes before turning the unit off.
•
Draining the water reservoir and refilling with fresh water at least once a week will greatly reduce
mineral deposits in the pads and help to extend the life of Honeycomb Cooling Media.
WARNING
•
Before cleaning the unit, switch it to the off position and remove the plug from the power socket.
•
To clean the outside, use a damp cloth to remove dirt and dust.
•
Never use corrosive elements or any chemicals to clean this product.
•
When the product is not in use, store the unit in a dry place out of direct sunlight.
12