GE Monogram ZBD5600 Use And Care Manual page 18

Light Bulb
The interior light bulb is located in the rear top right corner.
Replacement
To replace—
(on some
1. Make sure the dishwasher is disconnected from the
models)
2. Unscrew the plastic lens counterclockwise.
3. Remove the bulb and replace with a maximum 15 watt
4. Make sure the seal is correctly fitted to the plastic lens
Water fill
For best performance, check the water fill level of your
dishwasher.
level
Once the dishwasher is fully connected, run it through a
complete RINSE & HOLD cycle to ensure it is emptying and
filling correctly. For low water pressure situations run the
RINSE & HOLD cycle 3 times. Half way through the final
RINSE & HOLD cycle, pause the dishwasher and check the
water level inside the dishwasher. If the water level is not
above the minimum water level (marked on the lower spray
support tower), increase the fill level.
For Model ZBD5600—Remove the front kickplate and
change the Fill Time switch setting.
For Model ZBD5700 and ZBD5900—
1. Ensure the dishwasher is not running through a cycle.
2. Press the CLEAR button to select fill time, as per chart
3. To test time, press DELAY START. The dishwasher will
4. Once complete, press the WATER TEMP button to exit
18
power supply.
bayonet bulb no larger than 1" in diameter and 2" long.
Order part # WD21X10055.
and screw it firmly into place.
CAUTION: The plastic lens must be secured before
reconnecting power to the dishwasher.
ATTENTION : Il faut remettre la lentille de plastique
en place avant de rétablir le courant au lave-vaisselle.
Depress the WATER TEMP button for ten seconds until
the second buzzer sounds.
below (80 seconds is the factory setting).
start filling. Listen for the dishwasher to complete
filling. Once filled, the fill level must be checked to
ensure fill time is correct.
fill time mode.
Continue to press the
CLEAR button until
the desired indicator
is illuminated.
Care and Cleaning
Cycle Status
Indicators
PRE-WASH
WASH
RINSE
DRY
CLEAN
Dishwasher
Light bulb
Plastic lens
Maximum level
Fill time switch
Fill time
75 seconds
80 seconds
90 seconds
100 seconds
110 seconds
Unscrew lens in a
counterclockwise
direction
Minimum level