GE Monogram ZBD5600 Use And Care Manual page 16

In addition to the glass trap, your dishwasher
The Wash
has three fine filters—
Filters
• a two piece round perforated stainless steel
• a finer micro-mesh filter located under the
• a super fine filter located below the lower
Remove the stainless steel filter by first twisting
and removing the glass trap. Lift out the
stainless steel filter.
Attached to the underside of this filter is the
micro-mesh filter. To remove the micro-mesh
filter, squeeze the two clips above the stainless
steel filter to release the micro-mesh.
To remove the super fine filter, remove the
lower spray arm. Grasp the super fine filter
around the outer edges. Remove by pulling
upwards, it will unclip. Unscrew the tower
counterclockwise. The right half of the
stainless steel filter can now be removed.
To clean filters, place under running water
and gently brush with a soft bristled brush. Be
careful not to deform filters while cleaning, as
this may prevent them from being properly
re-installed.
The super fine filter is self-cleaning, there is no
need to clean it. This filter need only be
removed if you want to remove the right half of
the stainless steel filter.
Replace your filters in the reverse order,
starting with the right half of the stainless
steel filter. Then screw in the tower. Replace
the super fine filter over the tower by pressing
firmly on the outer edge until it clips into
place and reposition the lower spray arm.
Reconnect the micro-mesh filter to the left
half of the stainless steel filter prior to
replacing it back into the dishwasher. Then
replace the glass trap. Ensure that all filters
are replaced correctly for best results.
16
filter located in the base of the dishwasher.
stainless steel filter.
spray arm.
Care and Cleaning
Dishwasher
Grip filter and lift
to remove
Perforated stainless
steel filter
Pull super fine
filter up to remove
Lift stainless steel
filter to remove
Micro-mesh filter
Squeeze clips to remove
micro-mesh filter
Unscrew tower
counterclockwise
to remove