Reversing The Door Swing - GE GTR10 Owner's Manual And Installation Instructions

REVERSING THE DOOR SWING

7
INSTALL CENTER HINGE
ON THE LEFT
Remove the three plug buttons on the left side
and install them on the right.
Install the center hinge designed for the left side that
came with the refrigerator, with the screws, spacer
and washer(s) (on some models) that you removed
in Step 2.
Remove the tape holding the door shut.
CAUTION:
correctly, the hinge is tight against the cabinet.
ATTENTION: The screws must be properly
tightened. Turn the screws until snug. Then tighten
the screws a minimum of 1/2 turn using both hands.
Installation Instructions
When assembled
(CONT.)
8
REHANG THE FREEZER DOOR
Place the freezer door on the center hinge over
the pin.
Raise the top hinge by hand and insert the top
hinge pin into the hole in the door. Then swing
the door shut.
Transfer the plug button on top of the door
to the opposite side.
Plug button
9 ALIGN THE DOORS
Align the freezer door with the fresh food door so
that the gap between the doors is even.
Tighten the top hinge screws by turning them until
snug. Then turn the screws a minimum of 1/2 turn
using both hands.
Install the hinge cover over the top hinge.
12