Grass Bag Cleaning And Replacement; Engine Maintenance - Honda HRR216PKA Owner's Manual

either case, it would be possible for the blades to fly off while you
are operating the mower.
TORQUE WRENCH
TORQUE: 36 ~ 43 ft-lb
(49 ~ 59 N•m)
BLADES
SPECIAL
WASHER (2)
BLADE
BOLT (2)

GRASS BAG CLEANING AND REPLACEMENT

Cleaning
Wash the bag with a garden hose, and allow it to dry completely
before use; a wet bag will clog quickly.
Replacement
Replace a worn or damaged bag with a Honda replacement bag or its
equivalent (page 19).
Removal
1. Unclip the plastic edges of
the bag from the frame.
2. Remove the frame from
the bag.
Installation
1. Insert the frame into the
bag, as shown.
2. Clip the plastic edges of
the bag onto the frame, as
shown.
10
WOODEN BLOCK
BAG
PLASTIC EDGE
FRAME
PLASTIC
EDGE

ENGINE MAINTENANCE

Engine Oil Level Check
1. Unscrew and remove the filler cap/dipstick and wipe it clean.
2. Insert and remove the
dipstick without
screwing it into the filler
neck. Check the oil level
shown on the dipstick.
3. If the oil level is low, add
oil to reach the upper limit
mark on the dipstick. Do
not overfill. If the engine
is overfilled, the excess
oil may get transferred to
the air cleaner housing
and air cleaner filter.
NOTICE
Running the engine with
a low oil level can cause
engine damage.
4. Screw in the filler
cap/dipstick securely.
Engine Oil Recommendations
Oil is a major factor affecting performance and service life. Use
4-stroke automotive detergent oil.
Always change the oil in accordance with the MAINTENANCE
SCHEDULE (page 8).
Recommended oil for general use: SAE 10W-30
Other viscosities shown in the
chart may be used when the
average temperature in your area
is within the recommended range.
The SAE oil viscosity and service
classification are in the API label
on the oil container. Honda
recommends API service category
SJ or later oil.
FILLER
CAP/DIPSTICK
UPPER
LIMIT
LOWER
LIMIT
30
10W-30
0 20 40 60 80 100°F
-20 -10 0 10 20 30 40°C