Advertisement
Accessing the System
For a list of USB peripherals that have been tested on the Cisco ICS 7750, see the
Note
"Using Peripherals with SPE310s" section on page
Connect the monitor cable to the video port on the SPE310, and power on the
Step 1
monitor.
Do one of the following, based on the type of peripherals that you are using:
Step 2
•
•
Use the keyboard, mouse, and monitor to access standard Windows utilities on
Step 3
the SPE310, such as Windows Explorer and the Control Panel.
Cisco ICS 7750 Installation and Configuration Guide
5-10
USB—Connect a USB keyboard to one SPE310 USB port, and connect a
USB mouse to the other SPE310 USB port.
PS/2—Connect the "Y" splitter cable for your keyboard and mouse to the
keyboard/mouse port on the target SPE310. Then connect your keyboard and
mouse to the available ends of the "Y" splitter cable.
If you are using the "Y" splitter cable to connect a PS/2 mouse and a
Note
keyboard to the SPE310, the keyboard and mouse must be connected
at or before the time that the SPE310 is rebooted in order to be
recognized by the operating system. A USB keyboard and mouse are
usually recognized without rebooting the operating system.
Chapter 5
Operating the Cisco ICS 7750
5-19.
78-14165-03
Advertisement
