Operation - Extron electronics TLP VIM User Manual

d
Video input – Two female BNC connectors on pigtails used to
input either S-video (yellow-chroma, white-luma) or composite
video (white only).
For composite input, connect the composite cable to the white
video input cable.
For S-video input
connect the luma cable
to the white video
input and the chroma
cable to the yellow
video input.
e
MTP output – One female RJ-45 connector to output the MTP A/V
signal to the touchpanel.
The TP cable connecting the TLP VIM output to the MTP input of
the touchpanel is standard UTP or STP Cat 5 or better cable. The
ends may be terminated using either TIA/EIA 568A or TIA/EIA 568B
but both ends must use the same standard.
1 23 4 5 6 7 8
Insert
TP Wires
CAUTION:
The TLP VIM output uses higher voltages than a LAN. Inputting
those voltages on a LAN communications port may damage the
connection.

Operation

No setup or configuration is required. Once cabling is complete,
apply power to the connected equipment and TLP VIM. The unit is
ready for operation.
6 TLP VIM • Installation and Operation
Pins:
T568A
Pin Wire Color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown
NOTE: When using Enhanced Skew-Free™ A/V cable, use
the TIA/EIA T568A standard only.
White: Luma or
Composite
Figure 5.
MTP Signal
T568B
Wire Color
Composite
White-orange Reserved
Orange Reserved
White-green Mono audio+
Blue Video+
White-blue Video–
Green Mono audio–
White-brown Reserved
Brown Reserved
POWER
12V
0.5A MAX
AUDIO
Yellow: Chroma
Video Inputs
MTP Signal
S-video
Chroma+
Chroma–
Mono audio+
Luma+
Luma–
Mono audio–
Reserved
Reserved
INPUT