Setup Your Device As A Wireless Ap - Aztech WL556E User Manual

Setup Your Device as a Wireless AP

Use the WL556E as a Wireless Access Point to turn a regular modem-router
into a wireless capable networking device. Simply connect an Ethernet cable
from any available Ethernet LAN port on the modem-router to the Ethernet
port of the WL556E. The WL556E will serve as a wireless interface for your
wireless-enabled devices such as laptops and smartphones to connect to the
Internet via your existing modem-router.
To setup the device as a wireless AP
1. Connect an Ethernet cable from an available port in your modem-
router and connect the other end of the Ethernet cable to the Ethernet
port of the WL556E.
For a new Out-of-The-Box unit, No extra configuration is needed for the
WL556E to be used as a wireless AP. Simply connect an Ethernet cable
from your existing modem-router to the WL556E and you are ready to
surf the Internet wirelessly. If you have already made any configuration
on the WL556E, press the Reset button beside the Ethernet port for 5
seconds to restore the device to its factory default configuration.
:
User Manual
Page 13 of 34