HP Docking System User Manual page 30

Troubleshooting
Solving Problems
If you're using Windows 95 and OmniBook won't undock
Check to make sure that the network card is removed from the undocked
configuration. See "To remove a device from the undocked configuration" on
page 1-25.
From the Start menu, click Shut Down, then Restart the Computer in MS-DOS
mode. From MS-DOS, try undocking.
If the docking system makes a noise when you dock the OmniBook
There is nothing wrong with the hardware. This occurs on occasion when the
docking system motor pulls the OmniBook into place.
If you need to replace a lost or damaged power cord
For the replacement part number for the docking system power cord, contact the
number in the Support and Service booklet.
If a serial or parallel device or external display doesn't work
Make sure the OmniBook is fully inserted in the docking system. The
connection should be snug.
Reboot the OmniBook.
If an external PS/2 mouse or keyboard doesn't work
Make sure the OmniBook is fully inserted in the docking system. The
connection should be snug.
Make sure the mouse is plugged into the correct port. The mouse and keyboard
ports look the same. See page 1-17.
Turn the system off and on.
Reboot the system.
Undock the OmniBook, unplug and reconnect the ac adapter, then dock again.
If the network connections don't work
Make sure that the LAN cable is connected.
You normally lose connections when you turn off the system or undock. See if
your network software has a reconnect feature.
1-30