Pride Celebrity X LE Owner's Manual page 34

V I I . D I S A S S E M B L Y A N D A S S E M B L Y
DISASSEMBLY
You can disassemble the scooter into several
pieces: the seat, the front section, the rear section,
the rear shroud, the basket, and the batteries. See
figure 20. No tools are required to disassemble or
assemble your scooter, but keep in mind that the
disassembled sections of the scooter take up more
floor space than the assembled unit. Always
disassemble or assemble your scooter on a level,
dry surface with sufficient room for you to work
and move around your scooter—about 6 feet (2
meters) in all directions. Remember that some
scooter components are heavy and you may need
assistance when lifting them.
WARNING! Do not lift beyond your
physical
assistance when necessary while
disassembling or assembling your
scooter.
1. Place the scooter in drive mode by engaging the freewheel lever.
2. Lock the tiller in the straight ahead position by pushing the tiller lock knob in and turning it clockwise
90°. See figure 21. The front wheel must face forward in order to lock the tiller.
3. Remove the seat by lifting it straight up and off of the scooter. If you encounter resistance when
removing the seat, disengage the seat rotation lever and swivel the seat back and forth while lifting up
on the seat.
4. Gently pull the rear shroud up and off of the rear section of the scooter.
5. Unplug the front-to-rear and rear lighting harnesses by squeezing the sides and pulling straight up.
6. Unplug both battery harnesses. Pull each harness straight up. See figure 23.
WARNING! Failure to unplug both battery harnesses, the front-to-rear harness, and rear
lighting harness prior to separating the front and rear sections could result in permanent
damage to the scooter.
LOCKED
POSITION
Figure 21. Tiller Lock knob (Locked)
34
capability. Ask for
www.pridemobility.com
BASKET
REAR SECTION
REAR SHROUD
FRONT SECTION
Figure 20. The Scooter Disassembled
UNLOCKED
POSITION
Figure 22. Tiller Lock Knob (Unlocked)
SEAT
BATTERIES
Celebrity X LE