Seat Height Adjustment; Mirror Position - Pride Mobility CELEBRITY X Owner's Manual

V I . C O M F O R T A D J U S T M E N T S

SEAT HEIGHT ADJUSTMENT

The seat can be repositioned to different heights. See
figure 17.
1. Remove the seat and rear shroud from your
scooter. See VII. "Disassembly and Assembly."
2. Loosen the seat height adjustment nut and
remove it from the bolt. Remove the bolt.
3. Loosen the clamp-action bolt.
4. Raise or lower the upper seat post to the desired
seat height.
5. While holding the upper seat post at that height,
match up the locating holes in the upper seat post
with those of the lower seat post.
6. Insert the seat height adjustment bolt through the
locating holes of both the upper and lower seat
posts.
7. Install the nut onto the bolt and tighten.
8. Tighten the clamp-action bolt.
9. Reinstall the rear shroud and the seat.

MIRROR POSITION

To install the mirror (see figure 18):
1. Determine a side to install the mirror and remove
the rubber plug from the top of the tiller handle.
2. Insert the threaded end of the mirror holder into
the opening and rotate it clockwise until snug.
3. If necessary, rotate the nut clockwise to secure
the mirror in place.
To adjust the mirror:
1. Position yourself in a seated driving position
facing forward.
2. Adjust the mirror left, right, up, or down until
you have a good line of sight behind you.
32
Figure 17. Seat Height Adjustment
Figure 18. Mirror Installation
www.pridemobility.com
NUT
NUT
MIRROR HOLDER
NUT
UPPER SEAT POST
LOCATING
HOLES
SEAT HEIGHT
ADJUSTMENT
BOLT
CLAMP-ACTION BOLT
LOWER SEAT POST
PLUG
Celebrity X