Allowing Web Access To The Ip Phone - Cisco SPA301 Administration Manual

Getting Started
Using the Web-Based Configuration Utility
STEP 1
STEP 2
NOTE
STEP 3
STEP 4
STEP 5
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide

Allowing Web Access to the IP Phone

To view the phone parameters by using the phone web user interface, the
configuration profile must be enabled. To make changes to any of the parameters
by using the phone web user interface, the configuration profile must be writable.
Your system administrator might have disabled the phone option to make the
phone web user interface viewable or writable.
For more information, see the
Guide.
Cisco SPA303, Cisco SPA500 Series
To allow or disallow from the phone viewing of the phone web user interface:
Press the Setup button.
To display the Web Server Writable option either:
• Select Network > Enable Web Server.
• Select Settings > Security Configuration > Web Access Enabled.
This option is available in SPCP mode only.
Press Edit to change the status of the Web Access Enabled parameter.
If the option to edit the parameter is not displayed, press **# to display the option.
If the edit option still does not display, it might be set by your phone system
administrator such that you cannot modify this parameter.
Press Y/N to toggle the parameter and press ok to set the parameter.
To save your change, press save.
Making the Profile Writeable
On some models you can enable modifying the configuration profile by using the
phone web user interface or disable the ability to modify the profile making the
phone web user interface read only.
To toggle the write access:
Cisco Small Business IP Telephony Provisioning
1
23