Controls And Components - MULTIQUIP Mikasa MT-86D Operation And Parts Manual

Figure A shows the location of the controls and components
for the MT-86D Tamping Rammer. The functions of each
control is described below:
1. Fuel Tank/Cap – Remove this cap to add diesel fuel.
Use high grade automotive diesel fuel only.
Throttle Lever – Controls engine speed and the tamping
2.
action of the rammer.
3. Engine Oil Dipstick – Indicates the level of the engine oil
Use CC class or higer grade motor oil.
4. Oil filter – Prevents dirt and other debris from entering the
engine.
5. Oil Bath Fill Plug – Open this plug to add oil to the oil
bath reservoir.
6. Oil Level Sight Glass – Indicates the level of oil in the oil
bath reservoir.
7. Drain Valve – Open this valve to remove oil from the
bellows.
MT-86D — PARTS & OPERATION MANUAL — REV. #7 (09/02/04) — PAGE 11
MT-86D — CONTROLS AND COMPONENTS
Figure A. MT-86D Tamping Rammer
Foot – Laminated wood with tempered steel plate for
8.
superior shock absorption.
9. Muffler– Used to reduce noise and emissions.
10. Engine Air Cleaner – Prevents dirt and other debris
from entering the engine.
11. Decompression Lever – Use in the starting of the
engine. Press lever to engage. After engine starts lever
will return to original position.
12. Fuel Filter – Located inside fuel tank. Prevents dirt and
debris from entering fuel system.
13. Recoil Starting Handle – Used when starting the engine.
Pull starter handle sharply and quickly, then return
starter handle to starter case before releasing.
14. Handle – To operate rammer GRIP handle assembly
firmly on both sides.
15. Bellows – Reservoir for oil bath.